小型噴霧干燥機的安裝使用
產品說明書
開機前請仔細閱讀本說明書,若有疑問請及時與川一聯系。建議您D一次使用少量樣品進行實驗,并妥善保管此說明書以備不時之需。
Please read this instruction carefully before starting, if you have any questions, please contact with the company in time. The first time you use this equipment, please use a small amount of sample for experiment, and properly keep this instruction for a rainy day.
CY-8000Y主要適用于實驗室對液狀物料直接轉化為微量粉末,無需在干燥前對物料進行過濾、濃縮和粉碎,對所有溶液如乳濁液、懸浮液具有廣譜適用性。
CY-8000Y This Equipment is mainly suitable for laboratory for changing liquid material directly into micro powder, without filtration, concentration and smash before drying, the supplies for all solution is a broad applicability, such as emulsion, suspending liquid。
一、適用范圍Scope Of Application
本機主要適用于實驗室對液狀物料直接轉化為微量粉末,無需在干燥前對物料進行過濾、濃縮和粉碎,對所有溶液如乳濁液、懸浮液具有廣譜適用性。
This Equipment is mainly suitable for laboratory for changing liquid material directly into micro powder, without filtration, concentration and smash before drying, the supplies for all solution is a broad applicability, such as emulsion, suspending liquid。
二、隨機組件Random Component
序號serial number名稱name數量number
1玻璃干燥室Glass kiln1
2玻璃旋風分離器Glass cyclone separator1
3玻璃樣品收集瓶glass sample collection bottle 500ML1
4玻璃樣品收集管The glass sample collection tube1
5輸料硅膠管Transporting the silicone tube 6mm1.5m
6噴霧槍spray pistol1
7卡箍clamp(LY12)黑色black1
三、安裝說明Installation Instructions
a)干燥室的安裝
用雙手將干燥室托住然后插入干燥室固定托板上(置于白色PTFE墊塊上),鎖緊把手即可。
The installation of the Glass kiln :
Prop up the Glass kiln and then inserted into the fixed plate (PTFE in white on the block) , and lock the handle。
b)旋風分離器的安裝
將旋風分離器緊縮螺母、密封圈及不銹鋼墊片套入旋風分離器的出風管上,然后一起插入設備出風管中,調節干燥室出風口與旋風分離器進風口的位置,使兩個口平直對齊,用卡箍將兩個口連接起來,*后緊縮旋風分離器緊縮螺母。
The installation of cyclone separator:
Fit the cyclone separator nut, seal ring and stainless steel gasket into the air outlet of cyclone separator, and then inserted into the air outlet of device, adjust the position of the air outlet of the Glass kiln and the inlet of the cyclone separator, make two mouth straight alignment, by connecting two mouth clamp, at last tightening nut tightening cyclone separator
c)用螺紋連接器將集料瓶和旋風分離器連接起來
Connect the aggregate bottle to the cyclone separator with threaded connector
d)用螺紋連接器將集料管和干燥室連接起來
Connect the aggregate tube to the Glass kiln with threaded connector
e)將噴霧腔安裝到設備上,連接4mm氣管(通針用)和6mm藍色氣管(噴霧用)
Connect the spray chamber into the device, and then connect 4 mm trachea (using for needle) to 6 mm blue trachea (using for spray)
f)安裝食品級硅膠管至蠕動泵上,并插入噴霧腔進料口
Install the food-grade silicone tube to the peristaltic pump, and insert the inlet of the spray chamber
注意:所有玻璃器皿都為易碎品,安裝和清洗時注意小心輕放,確認所有的部件都已安裝就位后再上電操作。
Note: all glassware is fragile, handle with care when installation andr confirm all the components are installed in place before the electric operation。
四、操作說明Operating Instructions
1開機,顯示如下界面,請選擇中文或英文,點擊進入系統
Power On,and the screen displays as the following。Please select Chinese or English,and click it to enter the system
上一篇 索氏提取―重量法測定含油污泥 下一篇 小型噴霧干燥機在生產中可能出現的故障和解決方法